Sanyo PLC-XP17N Owner's Manual

Contents

Sanyo PLC-XP17N Owner's Manual Manual pdf 11 page image

11CONNECTING THE PROJECTORCONNECTING THE COMPUTERPersonal computers can be connected to the HDB15-pin (VGA) terminal on the projector. Connect the computer to these terminals using the VGA cable and VGA/Macintosh adapter (provided).CAUTION: For projectors, the VGA cable provided is designed to reduce RFI (Radio Frequency Interference) emissions.For regulatory compliance reasons, this cable must be used and must not be replaced by any other cable.CONNECTING TO THE COMPUTER INPUT TERMINALS (1 and 2)CONNECTING TO THE COMPUTER AUDIO INPUT JACKS (1 and 2)CONNECTING TO THE CONTROL PORT (DIN 8 PIN) CONNECTORS (1 and 2)5 4 3 2 110 9 8 7 615 14 13 12 11This terminal output the information of the selected computer source being viewed on the screen (Computer 1 or Computer 2).When video source is selected, this terminal outputs Computer 1 input information.An external monitor can be connected to the HDB15-pin (VGA) terminal on the projector. Connect the monitor to this terminal using the VGA cable (not provided).Pin No./Signal1 Red input2 Green input3 Blue input4 Sense 25 Ground (Horiz.sync.)6 Ground (Red)7 Ground (Green)8 Ground (Blue)Pin No./Signal9 Non Connect10 Ground (Vert. sync.)11 Sense 012 Sense 113 Horiz. sync14 Vert. sync15 ReservedHDB 15-PINTERMINALCONNECTING TO THE MONITOR OUTPUT TERMINAL Connect audio outputs from your computer to these jacks using the audio cable (not provided). If you wish to control the computer with projector's remote control unit, you must connect control port (PS/2, Serial orADB port) on your computer to projector's control port with cable. (three type cables supplied; for PS/2 Port, Serial Portand ADB Port).63812745 CONTROL PORT––––––––ADB––––––––GND––––––––––––––––––––––––GNDRXD––––––––––––––––GNDRTS/CTSTXDGNDGND–––––––-CLKDATAGND––––––––––––––––GND––––––––Serial Port ADB Port12345678PS/2 PortNOTE: The RXD port (1 pin on the Serial Port) is provided on control port 2 connector only. If you control the projector bycomputer, you must connect control port 2 connector.