Sanyo PLC-XP17N Owner's Manual

Contents

Sanyo PLC-XP17N Owner's Manual Manual pdf 39 page image

39COMPUTER MODEIMAGE ADJUSTDISPLAYTABLE OF PICTURE IMAGE ADJUSTMENTMAIN MENU DISPLAYNOTE:The projector may not reproduce a properimage for some SXGA signals.Since SXGA (1280 x 1024) image isconverted to 960 x 768 image by partial scan,some lines and dots of the image do notappear.Some video noise of flicker on thiscompressed SXGA image cannot beeliminated even though you try to make aFine sync adjustment.PICTURE IMAGE ADJUSTMENTWHITE BALANCE (R/G/B)CONTRASTBRIGHTNESS0 127636306300TOTAL DOTSFINE SYNCThe number of the total dots in one horizontal period. Adjust thenumber to match your PC image.Adjust the picture as necessary to eliminateflicker from the display.LIGHTER DEEPERDECREASE INCREASEDARKER BRIGHTERPicture adjustments have been preset at the factory. If you want to change the setting, operate the projector as follows.1. Press the MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear.2. Press the POINT LEFT/RIGHT BUTTON(s) to select IMAGE and press the SELECT BUTTON. Another dialog boxIMAGE ADJUST DISPLAY will appear. This shows the current picture settings.3. In this dialog box, you can adjust the settings by increasing or decreasing the levels shown as numbers. The itemsand the range of the levels that you can adjust are summarized in the table below.4. Press the POINT DOWN BUTTON and a red arrow will appear.5. Move the arrow to an item that you want to adjust by pressing the POINT UP/DOWN BUTTON(s).6. To increase the level, point the arrow to and then press the SELECT BUTTON. To decrease the level, point thearrow to and then press the SELECT BUTTON.7. You may want to store the settings in the memory so that you can recall them later. To store the settings, move thearrow to Stored and then press the SELECT BUTTON. When you have stored the settings, "OK ?" is displayed forconfirmation.8. Move the arrow to Yes and then press the SELECT BUTTON. The stored settings are memorized even if the MAINON/OFF is switched off.9. To quit the MENU, move the arrow to Quit and then press the SELECT BUTTON.10.If you do not want to store the settings, move the arrow to Quit and then press the SELECT BUTTON. The settingschanged remains effective until the MAIN ON/OFF switch is turned off.11.To recall the settings from the memory that you have stored, move the arrow to Reset and then press the SELECTBUTTON. When you have reset the settings, "OK ?" is displayed for confirmation. Move the arrow to Yes and thenpress the SELECT BUTTON. You can adjust the settings again if needed.NOTE: The "Fine sync." and "Total dots" cannot be fully adjusted when "RGB", "HDTV1035i" or "HDTV1080i" isselected on the COMPUTER SYSTEM SELECT menu. (See pages 36 ~ 37).