Sanyo PLC-XU30 Owner's Manual

COMPUTER INDIGITALMCIS – VIDEOR – AUDIO IN – L VIDEOY – Pb / Cb – Pr / CrRESETCONTROL PORTUSBCOMPUTER INANALOGAUDIO INCOMPUTER R – – LAUDIO OUT(MONO)11CONNECTING PROJECTORTERMINALS OF PROJECTORWhen controlling the computerwith Remote Control Unit ofthis projector, connect themouse port of your personalcomputer to this connector.(Refer to P13.)Connect the S-VIDEOoutput from videoequipment to thisjack. (Refer to P12.)Connect the audio output(stereo) from computer tothis jack. (Refer to P13.)Connect the audio outputfrom video equipment tothese jacks.(Refer to P12.) When the audio outputis monaural, connect itto L (MONO) jack.CONTROL PORT CONNECTORCOMPUTER AUDIOINPUT JACKAUDIO INPUT JACKS VIDEO INPUT JACKSS-VIDEO INPUT JACKConnect the composite videooutput from video equipmentto VIDEO/Y jack or connectthe component video outputsto VIDEO/Y, Pb/Cb andPr/Cr jacks. (Refer to P12.)Connect the computer(digital/analog) output toone of these terminals.(Refer to P13.)COMPUTER INPUTTERMINALS (DIGITAL/ANALOG)This projector has input and output terminals on its back for connecting computers and video equipment. Refer to figures onpages 11 to 13 and connect properly.Connect an externalaudio amplifier to thesejacks.(Refer to P12, 13.)AUDIO OUTPUT JACKSThis projector uses a microprocessor to control this unit,and occasionally, this microprocessor may malfunctionand need to be reset. Thiscan be done by pressingRESET button with a pen,which will shut down andrestart the unit. Do not useRESET function excessively.RESET BUTTONWhen controlling the computerwith Remote Control Unit of thisprojector, connect USB port ofyour personal computer to thisconnector. (Refer to P13.)USB CONNECTOR (Series B)✽ Do not press this button. This buttonis used for our optional accessories.