Sanyo PLC-XU30 Owner's Manual

NOTE ON THE POWER CORDAC Power Cord must meet requirement of the country where you use a projector.Confirm an AC plug type with the chart below and proper AC Power Cord must be used.If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.SETTING-UP PROJECTOR8PREPARATIONTo POWER CORDCONNECTOR on yourprojector.Projector side AC Outlet sideGroundTo the AC Outlet.(120 V AC)For Continental EuropeFor the U.S.A. and CanadaThis projector uses nominal input voltages of 100-120 V or 200-240V AC. This projector automatically selects the correct inputvoltage. It is designed to work with single-phase power systemshaving a grounded neutral conductor. To reduce risk of electricalshock, do not plug into any other type of power system.Consult your authorized dealer or service station if you are not sureof the type of power supply being in use.Connect a projector with a peripheral equipment before turning aprojector on. (Refer to pages 11 ~ 13 for connection.)CAUTIONFor safety, unplug AC Power Cord when an appliance is notused.When this projector is connected to the outlet with AC PowerCord, an appliance is in Stand-by Mode and consumes a littleelectric power.CONNECTING AC POWER CORDConnect AC Power Cord (supplied) to a projector.The AC outlet must be near this equipment andmust be easily accessible.For the U.K.To the AC Outlet.(200 - 240 V AC)To the AC Outlet.(200 - 240 V AC)