TEC MA-1350-1 SERIES Owner's Manual

Also see for TEC MA-1350-1 SERIES: Programming manual

Contents

TEC MA-1350-1 SERIES Owner's Manual Manual pdf 41 page image

- 34 -EO1-11126MA-1350-1 SERIES(or , )Returned MerchandiseDepress prior to or any time (before the finalkey at the latest) during the entrysequence of the following operations:Department EntriesPLU EntriesPercent Discount/Charge on a Department orPLU Item(NOTE 1)NOTES: 1. When an item once purchased with a Percent Discount or Percent Charge is returned, theitem can be returned with the Percent Discount/Charge by attaching the [RTN MDSE] key tothe same entry procedure as purchase.At Purchase At ReturnMEAT 7.00 TF%-5% 0.35-RTNMEAT 7.00-TF%-5% 0.35The process of the amount resulted from % calculation is reversed at Return.RTNMDSE2. The Returned Merchandise entries are possible outside as well as inside a sale. Over-subtraction of the sale is allowed for Returned Merchandise entries.3. Neither Negative Department nor Negative PLU items can be entered as Returned Merchan-dise.4. Returned Merchandise transaction can be programmed to require the MGR position of theControl Lock. If so programmed, an error will occur on depressing the [RTN MDSE] key inthe REG position. In this case, ask the store manager to turn the Control Lock to the MGRposition for the transaction. (Refer to the chapter 1. Operations in “MGR” Mode on page 1in Manager’s Guide.)Non-add Number PrintDept. 1 (MEAT) $7.00 isentered but returned.RTNMEAT 7.00-TF. . . #/NSCode Number;Max. 8 digitsNOTES: 1. The preceding zeros, if any, will not be printed. For example, if “0123000” is entered,“123000” is printed.2. Usually, Non-add Number entries are prohibited at the starting of a No-sale transaction (i.e.Non-add Numbers cannot be printed on a No-sale receipt). However, a No-sale entry can beprogrammed to be allowable after a Non-add Number entry (ask your TOSHIBA TECrepresentative).3. Usually, Non-add Number entry is allowed multiple times in one sale. However, it can beprogrammed to be allowed only once (ask your TOSHIBA TEC representative).#123000# #/CID