TEC MA-1350-1 Series Programming Manual

Contents

TEC MA-1350-1 Series Programming Manual Manual pdf 20 page image

- 18 -EO3-11084MA-1350-1 SERIESCondition for Programming Operations:At the top of each programming operation sequence in this chapter, “Condition” is attached. Unlessthe register satisfies this condition, the programming operations will not be allowed.When Condition “After ... Reset” is attached:“After ... Reset” means that the designated reset report must be taken before entering the program-ming (setting) operation. An error will result if the operation is attempted without taking the report.However, it does not necessarily mean “immediately after ...” When the designated reset report hasalready been taken and then some operations are performed in the “X”, “Z”, or “SET” mode, thecondition “After ... Reset” is still satisfied and the programming operation is stilled allowed. On thecontrary, when the designated reset report has been taken but then some sales data relating tothat report’s output data are entered in the “REG”, “MGR” or “ - ” mode, the programming opera-tion will no longer be allowed and the same reset report must be taken again. Thus, the condition“After ... Reset” indicates that all the sales data relating to the report data must be zero (except non-resettable memory data). Because of this “Condition” requirement, the report data will be protectedfrom any inconsistencies of sales data entered in the period from a resetting of the report to anotherresetting of the same report next time.When Condition “Any time outside a sale” is attached:It means that no condition is specified to a programming (setting) operation, and that the operationis allowed any time outside a sale (but the cashier must be signed off if the Cashier Signing Methodoption is selected).