TEC MA-1350-1 Series Programming Manual

Contents

TEC MA-1350-1 Series Programming Manual Manual pdf 87 page image

- 85 -EO3-11084MA-1350-1 SERIESTax/PST Table SettingCondition: After Daily Financial ResetProgramming Procedure:Example)To set the limit amount ($20.00) for the [VND CPN] key:Key Operation: Control Lock: SET1) Tax 1; Full Breaks (Non-cyclic Breaks + Cyclic Breaks)|max. amount non-taxable| →|max. amount for 1¢ tax levied| →|max. amount for 2¢ tax levied| →Repeat up to the “A” Break.|max. amount for N¢ tax levied| → .....“A” Break(to indicate the “A” Break entry)|max. amount for N + 1¢ tax levied| →|max. amount for N + 2¢ tax levied| →Repeat up to the “B” Break.|“B” Break| →(“B” Break - “A” Break= a multiple of $1.00)(to complete this tax table setting)NOTE: Each amount (break) entry may be a maximum of 4-digit value (9999¢).2) Tax 1; “A” Break and % Rate Combination (Non-cyclic Breaks + % Rate)First, set all the non-cyclic breaks up to the “A” Break entry and the [ST] key depression shown in theabove case of “1) Tax 1 Full Breaks”.↓|Tax Rate applied when exceeding the “A” Break amount|(Max. 6 digits up to 99.9999%. Use the [ . ] key for a decimal value. Examples: To set 5%, enter 5. Toset 5.26%, enter 5 → [ . ] → 2 → 6. The fraction of the amount resulting from this % rate calculationwill be rounded off.)↓(to complete this tax table setting)TX1/MTX1/MTX1/MTX1/MTX1/MTX1/MAT/TLSTAT/TLNon-cyclicTax BreaksCyclicTax Breaks