TEC MA-1350-1 Series Programming Manual

Contents

TEC MA-1350-1 Series Programming Manual Manual pdf 25 page image

- 23 -EO3-11084MA-1350-1 SERIESt 1 1STtt #/NS AT/TLttRepeat for Bit status changes in all the required Addresses.Bit Nos. that are set to “SET” status(max. 8 Bit Nos. combination of 1 to 8)Address No. (max. 2digits; 1 to 23)( )#/CIDorSystem Option SettingThis operation is provided for your selections of the register’s basic functions according to the market andyour requirements.Programming ProcedureThe System Options are divided into 22 addresses (Addresses 1 to 23; Address 10 is vacant) and eachaddress is further divided into a maximum of 8 bits (Bits 1 to 8). Each address table is placed on the followingpages.Condition: After Daily Financial ResetProgramming Procedure:Use the MA Key to turn the Control Lock to “SET” or the S Key to turn the Control Lock to “BLIND”.To access Addresses 1 to 13:To access Addresses 1 to 17:To access all Addresses 1 to 23:ZREGXSET-OFFMGRt 1 8ZREGXSET-OFF(BLIND)MGRt 1 8t @/FOR#,Enter a maximum of eight-digit number composed of Bit Nos. whose status must be set to the “SET” statusin the Address. If there is no Bit Nos. to be set to the “SET” status, enter “0” for the Address.Examples) To set Bit 2 only .............................. Enter 2.To set Bits 2 and 3 ......................... Enter 23.To set all the Bits ............................ Enter 12345678.To reset all the Bits ......................... Enter 0.To change any Bit in an address, enter the Address No. and enter all the SET Bit Nos. again. If a Bit No.is not included in the SET Bit Nos., the Bit will be RESET.