Chapter 3: Printer Menus and the Control Panel 3–59Config Menu⇒ PrinterConfig MenuFollowing are explanations of each category andparameter in the Config Menu. For all availableoptions under each parameter below, consult theHelp Menu printout. The categories here arePrinter, Codes, Graphics, Configurations, SerialI/O, Parallel I/O, IntelliFilter, and when theoptions are installed, Twinax/Coax and IPDS.Printer CategoryUse the Arrow and Enter keys to selectMenu => Config Menu => Printer to gethere.PowerupThis parameter sets the printer either Online or Offline when the power switch isturned on. The default is Offline.Ser/Par EmulationThis parameter allows you to define which set of printer control commands willbe emulated for data received on the Serial and Parallel ports (except LAN-IPDS). Tally ANSI is the default selection.When a new emulation setting is entered through the Printer Control Panel,emulation dependent parameters in the Current configuration are changed tomatch the default settings for the selected emulation. The following table liststhose parameters by emulation:Parameter Tally ANSI Genicom ANSI P5000 P6000 P600Character Set Latin1 Code Pg 437 Code Pg 850 Latin1 Latin1OCR-A ANSI ANSI ANSI ANSI ANSIOCR-B ANSI ANSI ANSI ANSI ANSIAuto CR OFF ON ON ON OFFLine Wrap OFF ON OFF OFF OFFWrap LF OFF ON OFF OFF OFFCode 7F FILL FILL Space Space SpaceVT Channel 2 12 N/A 12 12SkipWhen Before Before N/A After After
