3–60 Operator ManualParameter HP 2564C DEC LG01 Epson FX-1180 IBM Proprinter MTPLCharacter Set Roman-8 DEC Italic Code Pg 437 Code Pg 437OCR-A ANSI ANSI ANSI ANSI ANSIOCR-B ANSI DIN ANSI ANSI ANSIAuto CR OFF OFF ON ON ONLine Wrap OFF OFF ON ON ONWrap LF OFF OFF ON ON ONCode 7F Fill FILL Delete Char Ignore Delete BufferVT Channel 12 12 N/A N/A N/ASkipWhen After After N/A N/A N/AConfig Menu⇒ PrinterLAN Emulation (LAN Interface only)This parameter is used to select the emulation attached to the Ethernet port whenusing the LANPlex interface. The options are the same as for the Ser/Par Emula-tion.Twinax Emul (Twinax/Coax only)This parameter is used to select the Twinax emulation when using the FourPlexinterface. The options are IBM 4234, IBM 4210, and IBM 5225. The default isIBM 4234. The Coax emulation will always be IBM 4234.Dump ModeThis parameter is used to troubleshoot problems that may arise when processingdata. It places the printer into a Hex Dump Mode. You can select three styles ofprintouts for use as debugging tools. The selections are:OFF: Dump Mode is disabled. (Default selection)Style1: Two column output. Text, spaces, and control codes are printed inhexadecimal code format in one column and ASCII equivalents inanother column.Style2: Only control codes are printed in hexadecimal format. ASCII charactersare printed as is and escape sequences force a new line.Style3: Control codes and spaces are printed in hexadecimal format. ASCIIcharacters are printed as is and escape sequences force a new line.Twinax InterfaceThere is only one style for Twinax. It is similar to the Serial/Parallel Style 1,except the Hex codes are EBCDIC instead of ACSII.Coax InterfaceThere is only one style for Coax. It is a unique dump mode that prints thecontents of the PCIA buffer associated with each data buffer.IPDS OptionIf the IPDS option is installed, the dump from the IPDS data stream will beuniquely formatted regardless of the Dump Mode selection.I/O Hold TimeThis parameter allows you to set the amount of time the printer remains lockedonto the I/O on which it is receiving data after data transmission stops. You canset this to be 5 - 600 seconds. Default is 30 seconds.
