Chapter 2: Loading Paper and Printing 2–29Figure 2 - 6. Top of Form NubbinFine-tuning the Column Alignment can be done in two ways:(1) Rotate the Horizontal Vernier Wheel, which is located on the right end of theshaft on which the tractors ride. Depending upon the direction the paper needs tomove, you will rotate the wheel either upwards or downwards.(2) Use the Control Panel. Go Offline, choose Menu, then use the arrow keys toget to the Operator Menu. Press Enter. Use the arrow keys to get to Forms. PressEnter. Use the arrow keys to get to Horz Adjust. Press Enter. Use the arrow keysto increase or decrease the number that appears in the lower right of the LCD.This will shift the position of Column 1.Step 7.Set the Top of the Form (TOF). This is done from the Control Panel. If theprinter is not on, turn it on now. If necessary, press the Online key until “Offline”is displayed. Use the up or down arrow keys to move the perforation line on thepaper so that it is aligned with the nubbin on the tractor door. Once the paper ispositioned, press the TOF key. The paper will move downward to the “ready toprint” position and the correct print gap will be set based on the form thickness.Standard Printing ModeNubbin- - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
