Chapter 3: Printer Menus and the Control Panel 3–65TOF Control (Available when Genicom ANSI emulation is selected)When a new form is defined, the top-of-form position is left unchanged if thisparameter is Enabled (the default). When a new form is defined, and this param-eter is Disabled, the top-of-form position is reset to the top margin of that form.DC3 Operation (Available when Genicom ANSI emulation is se-lected)This parameter allows DC1 - DC3 operation. When Enabled (default), the printercan be selected and deselected using DC1 and DC3 control codes. The printerselect/deselect operation is not in effect when Disabled.SISO OverszBar (Available when Genicom ANSI emulation is se-lected)This parameter allows SI-SO operation for bar codes and oversize characters.When Disabled (default), bar code and oversize character modes do not need tobe activated with SO and deactivated with SI. When Enabled, bar code andoversize character modes will be activated and deactivated using the SO and SIcontrol codes.Barcod Top Pos (Available when Genicom ANSI emulation is se-lected)When Enabled (default), the paper position is reset to the top of the bar codeafter printing. When Disabled, the paper position is left at the end of the bar codeafter printing.Oversz Top Pos (Available when Genicom ANSI emulation is se-lected)The paper position will be reset to the top of the oversize characters after printingwhen this parameter is Enabled (default). When Disabled, the paper position isleft at the end of the oversize characters after printing.Config Menu⇒ Codes
