3–64 Operator ManualConfig Menu⇒ CodesCode 7FThis parameter allows you to dictate how the printer will react when it receives aHexadecimal code 7F. The default value depends on the emulation. (See theEmulation Parameter, presented earlier in this chapter.)Ignore: The code is ignored.Delete Char: The previous character is deleted.Delete Buffer: The previous characters on the current print line are deleted.Space: A Space character is substituted.Fill: A Fill character is substituted.Print 80 - 9F HexThis parameter defines whether locations 80 through 9F Hex are to be treated ascontrol characters or printable characters. The function of the control charactersin this area depends on the emulation. The options are ON (printable charac-ters) – the default, or OFF (control characters).Ignore CharThis parameter allows you to select a character that will be ignored in the incom-ing data stream. Ignore Char functions in all emulations and non-downloadableprint modes. It does not function in plot mode, font download, or VFU down-load. Options are 0-255, referring to the decimal value of any 8-bit character, orOFF. Default is OFF.Sub Char FromThis parameter allows you to select a character that will be replaced by thecharacter designated by the Sub Char To parameter. It functions in all emulationsand non-downloadable print modes. It does not function in plot mode, fontdownload, or VFU download. Default is OFF.Sub Char ToThis parameter allows you to select the character that will replace the characterdesignated by Sub Char From. It functions in all emulations and non-downloadable print modes. It does not function in plot mode, font download, orVFU download. Default is OFF.PTX SFCC (Only affects the Printronix P5000 emulation)Defines the Special Function Control Character used by the Printronix P5000emulation. The decimal value of the ASCII character code is entered. The defaultvalue is 1 (SOH).PTX ALS (Only affects the Printronix P5000 emulation)Defines the single line Alternate Line Spacing used by the ACK (Hex 06) com-mand in the Printronix P5000 emulation. The options are 8 or 10.3 which definethe line density. The default value is 8.
