68 RTR-61 Registration[Delete Repeater] ButtonDeletes the last Repeater in the Relay Route listed in the current display fromthe Remote Unit Group List and Registration List; only the last unit can bedeleted.- Any Repeater other than the last one in the Route cannot be deleted.- If you wish to delete Repeater(s) other than the last one in the Route, it is necessaryto either delete each Repeater in sequence from the last to the one(s) you wish todelete, or delete the entire Relay Route itself (as above in "Delete Route") andregister Repeaters to design a Route again.Replacing Repeater1. Connect the one you wish to newly register to your computerwith a USB Communication Cable.2. Click the [Replace Unit] button. The newly replaced Repeater willbe registered with exactly the same registration contents as theold one.Select the Repeater[Replace Unit] Button[Repeater Info / Delete / Initialize] Tab- If you wish to replace a Repeater with a new one due to malfunction or troublewithout changing the Route design, connect the new Repeater to the computerand click this button.- After having replaced a Repeater with a new one, the registration info remains inthe Repeater that you had been using. Make sure to initialize it or remove thebatteries when not in use.- All Remote Units that were registered for communication via the Repeater that is tobe replaced will be automatically connected to the Base Unit for communication. Ifyou wish to communicate with the Remote Units via the newly added Repeater, itis necessary to manually move them in the Registration List so they connected forcommunication via the new unit.
