1 – Introduction—Environmental considerationsTASCAM CD-RW2000 9from sources of heat such as radiators or heat-gen-erating electrical devices.• Always store CD-R discs in their “jewel cases” toavoid dirt and dust accumulating on their surfaces.• Do not put labels or protective sheets on the discsand do not use any protective coating spray.• When labeling CD-R discs, always use a soft oil-based felt-tipped pen to write the information.Never use a ball-point or hard-tipped pen, as thismay cause damage to the recorded side.• Dirty discs may be cleaned using a soft dry clothand/or a commercial CD cleaning fluid or ethylalcohol. Do not use thinner, gasoline, benzene orLP cleaning fluid, as these will damage the disc.• If you are in any doubt as to the care and handlingof a CD-R disc, read the precautions supplied withthe disc, or contact the disc manufacturer directly.1.4.5 Recommended mediaAn up-to-date list of manufacturers who producemedia suitable for use in the CD-RW2000 can beobtained from your TASCAM dealer, or found on theTASCAM Web site at http://www.tascam.com.1.4.6 Default settingsThe default settings when the CD-RW2000 isshipped from the factory are given below.1.4.7 Dimensional drawingSetting Description Default valueInput selection 4.1, “Input selection” UnbalancedAuto track(A_TRACK)4.3.2, “Automatic trackdivision”OnAuto ready(A_READY)3.5, “Auto Ready func-tion”OffAuto cue(A_CUE)3.6, “Auto Cue function” OffIncremental play(INC PLAY)3.7, “Incremental play” OffWord sync(WORDSYNC)2.4.1, “Word sync con-nections”OffCopy ID (COPY ID) 4.4, “Copy-protection” 1 generationDigital direct(D_DIRECT)4.3.3, “Digital direct” OffTrigger level(S_LEVEL)4.3.1, “Synchronizedrecording”–54 dBFADE IN time 4.3.5, “Fade-in andfade-out”3 secondsFADE OUT time 4.3.5, “Fade-in andfade-out”3 secondsDigital Volume 4.1.1, “Signal volume” 0 dBPlay mode 3.1.3, “Playbackmodes”ContinueTrim 4.5, “Rehearsal” ±0 frames483mm(19.0")465mm(18.3"))21mm(0.8") 12mm(0.5")284.5mm(11.2")435mm(17.1")76mm88mm98mm(3.0")(3.5")(3.9")