Tascam CD-RW901 Owner's Manual

Also see for CD-RW901: Specifications Service manual Consultant’s Specification Owner's manual Specifications

1 TASCAM CD-RW901Display!SD F G HJ# ^ & * ( ) WTYUIOPQ$@A%ERThis display shows various types of operation informa-tion, including CD disc information, deck operationmodes, and menu status.! TOC The TOC indicator lights up red when a loadeddisc contains TOC (Table of Contents) data.@ Track number display During playback or selec-tion, the track number is displayed.When Incremental playback is on, and when in play-back or playback ready mode, the TRACK indicatorblinks.# MP3 The MP3 indicator lights when a MP3 disc is inthe deck.$ Counter display Depending on the time displaymode, TOTAL or REMAIN are lit. The counter displayindication are in minutes (three digits) and seconds(two digits).% KEY The KEY indicator lights when Key Control ison.^ PITCH The PITCH indicator lights when PitchControl is on.& A.CUE The A.CUE indicator lights when Auto Cue ison.* A.READY The A.READY indicator lights when AutoReady is on.( A. TRACK The A.TRACK indicator lights when the AutoTrack is on.) Meter This displays the playback level, as well asthe input level of the source device.Q A-B The A-B indicator lights when the A-B repeatfunction is on.Also, this flashes until a “B-point” is entered.W REPEAT The REPEAT indicator lights when theRepeat function is on.E SYNC The SYNC indicator lights up when SYNC ison.R REC When the SRC function is on, this lights dur-ing recording, or in recording standby mode.When the SRC function is off, this flashes duringrecording, or in recording standby mode.b ATT control right and left Use a small Phillipsscrewdriver with these attenuators to reduce the out-put level from either the right or left balanced analogoutput. The adjustable level is up to -10 dB.n ANALOG OUT (BALANCED) (L, R) These XLRconnectors output analog audio signals at +4 dBu tosuitably-equipped units.The wirings are: 1=grounding, 2=hot, 3=cold.m CONTROL I/O (parallel) terminal Use this 15-pinD-sub connector to connect the unit to suitably-equipped units, allowing control of the CD-RW901.The pinouts of this connector are described (seeConnections” on page 9)., CONTROL I/O (RS-232C) terminal RS-232C com-patible serial control from an external PC can beperformed.. REMOTE IN terminal Connects the suppliedRC-RW901 remote control unit./ AC IN jack Connects the power cable supplied.2 − Features of the CD-RW901