1 − Introduction TASCAM CD-RW901The CD-RW901 has been designed for the playback ofCD-DA (standard audio) format discs and MP3 filesrecorded on the discs using the ISO9660 format: Inaddition to ordinary 5-inch and 3-inch CDs, it can alsoplay properly recorded CD-R and CD-RW discs.Always place the compact discs in the trays withtheir label facing upward.To remove a disc from its case, press down on thecenter of the disc holder, then lift the disc out, hold-ing it carefully by the edges.Avoid getting fingerprints on the signal side (thenon-label side). Grime and dust may cause skipping,so keep discs clean and store them in their caseswhen not being played. To clean the signal side of adisc, wipe gently with a soft dry cloth from the cen-ter towards the outside edge.Do not use any record spray, anti-static solutions,benzene, paint thinner or other chemical agents toclean CDs as they could damage the delicate playingsurface. It may cause CDs to become unplayable.Discs should be returned to their cases after use toavoid serious scratches that could cause the laserpickup to “skip.”Keep discs away from direct sunlight, and places ofhigh heat and humidity. If left in such places, warp-ing could result.••••••Do not affix any labels or stickers to the label sideof the disc. Do not write on the disc with a ballpointpen.Do not insert discs that have adhesive remainingfrom tape or stickers that have been removed. If theyare inserted into the player, they could stick to theinternal mechanism, requiring removal by a techni-cian.Do not use cracked discs.Only use circular compact discs. Avoid using non-circular promotional, etc. discs.The CD-RW901 cannot play unfinalized CD-R/RWdiscs.Music discs with copy control, a copy-protectionsystem, have been released form several recordcompanies in an attempt to protect the copyright.Since some of these discs do not comply with theCD specifications, they may not be playable on theCD-RW901.••••••Handling of compact discsEnvironmental considerationsThe CD-RW901 may be used in most areas, but tomaintain top performance, and prolong operating life,observe the following environmental conditions:The nominal temperature should be between 5°C and35°C (41°F and 95°F).Relative humidity should be 30 to 90 percent.As the unit may become hot during operation, alwaysleave sufficient space above the unit for ventilation.Do not install this unit in a confined space such as abookcase, and do not put anything on top of the unit.•••Avoid installing this unit on top of any heat-generat-ing electrical device such as a power amplifier.Make sure that the unit is mounted in a level positionfor correct operation.NOTEThe voltage supplied to the unit should match thevoltage as printed on the rear panel. If you are inany doubt regarding this matter, consult an electri-cian.••