IMPORTANT SAFETY PRECAUTIONS1 TASCAM CD-RW901SL2 − Features of the CD-RW901SL1 TASCAM CD-RW901SLDisplay@DF G H JK$ & * ( ) Q EYUIOPAW%#S^RTThis display shows various types of operation information,including CD disc information, deck operation modes, andmenu status.@ TOC The TOC indicator lights up red when a loaded disccontains TOC (Table of Contents) data.# Track number display During playback or selection,the track number is displayed.When Incremental playback is on, and when in play-back or playback ready mode, the TRACK indicator blinks.$ MP3 The MP3 indicator lights when a MP3 disc is inthe deck.% Counter display Depending on the time display mode,TOTAL or REMAIN are lit. The counter display indicationare in minutes (three digits) and seconds (two digits).^ KEY The KEY indicator lights when Key Control is on.& PITCH The PITCH indicator lights when Pitch Control is on.* A.CUE The A.CUE indicator lights when Auto Cue is on.( A.READY The A.READY indicator lights when AutoReady is on.) A. TRACK The A.TRACK indicator lights when the AutoTrack is on.Q Meter This displays the playback level, as well as theinput level of the source device.W A-B The A-B indicator lights when the A-B repeat func-tion is on.Also, this flashes until a “B-point” is entered.E REPEAT The REPEAT indicator lights when the Repeatfunction is on.R SYNC The SYNC indicator lights up when SYNC is on.T REC When the SRC function is on, this lights duringrecording, or in recording standby mode.When the SRC function is off, this flashes duringrecording, or in recording standby mode.Y OPTICAL The OPTICAL indicator lights when the inputsource is set to optical.U COAXIAL The COAXIAL indicator lights when the inputsource is set to coaxial.c DIGITAL IN/OUT (AES/EBU) These two XLR connec-tors accept and output digital audio in standard profes-sional format.v ANALOG INPUT (BALANCED) (L, R) These XLRconnectors accept analog audio signals at +4 dBu fromsuitably-equipped units.The wirings are: 1=grounding, 2=hot, 3=cold.bm ATT control right and left Use a small Phillipsscrewdriver with these attenuators to reduce the outputlevel from either the right or left balanced analogoutput. The adjustable level is up to -10 dB.n ANALOG OUT (BALANCED) (L, R) These XLRconnectors output analog audio signals at +4 dBu tosuitably-equipped units.The wirings are: 1=grounding, 2=hot, 3=cold., CONTROL I/O (RS-232C) terminal RS-232C compati-ble serial control from an external PC can be performed.. CONTROL I/O (parallel) terminal Use this 15-pinD-sub connector to connect the unit to suitably-equipped units, allowing control of the CD-RW901SL.The pinouts of this connector are described (seeConnections” on page 9)./ REMOTE IN terminal Connects the suppliedRC-RW901SL remote control unit.! AC IN jack Connects the power cable supplied.