TASCAM DA-6400/DA-6400dp 112 – Names and Functions of Partsa SHIFT buttono When the Home Screen is open, press the MULTI JOGdial while pressing and holding this button to show awhite frame in the meter section, and turn the MULTI JOGdial to select the audio channel to be output from thePHONES jack.o When the Home Screen is open, press and hold the MULTIJOG dial while pressing and holding the SHIFT button toswitch the headphone monitoring mode between STEREOand MONO. (See “Setting headphones monitoring mode”on page 20.)o When the meter mode setting is 32ch, press the HOME[METER] button while pressing and holding this buttonto switch between showing level meters for channels 1-32and 33-64 on the Home Screen. (See “Setting the metermode” on page 53.)o Press the INFO button while pressing and holding thisbutton to open the MARK INFO page.o Press the MENU button while pressing and holding thisbutton to open the menu pages in the opposite direction.o When an audio output channel is selected on the HomeScreen, when a channel is selected for setting changes onthe REC FUNCTION or INPUT MONITOR screen, orwhen a folder is selected on the BROWSE screen, turn theMULTI JOG dial while pressing and holding this button tomove the cursor by large amounts.When stopped, in playback standby or playing back.o Press this button while pressing and holding the .[MARK .] button to move to the previous mark andresume the previous state.o Press this button while pressing and holding the /[MARK /] button to move to the next mark andresume the previous state.Rear panel8 DA-6400 rear panel8 DA-6400dp rear panels SLOT 2Use this slot to install an I/O card (sold separately).d SLOT 1Use this slot to install an I/O card (sold separately).f TIMECODE IN connectorThis BNC connector is for the input of SMPTE timecode.g TIMECODE OUT connectorThis BNC connector is for the output of SMPTE timecode.h WORD/VIDEO THRU/OUT connectorThis BNC connector is for the output of word clock and videoreference signals.This connector outputs word clock signals (thru or 44.1, 48,88.2 or 96 kHz) and video reference signals (signal thru fromIN jack).j WORD/VIDEO IN connectorThis BNC connector is for the input of word clock and videoreference signals. Use this connector to input word clocksignals (44.1, 48, 88.2 or 96 kHz) and video reference signals(NTSC/PAL blackburst and HDTV tri-level).k ETHERNET connectorThis is an Ethernet port. Use this to connect to a network,transfer files and control the unit externally.l RS-422 terminalThis is a 9-pin D-sub RS-422 serial control terminal.Connect an external controller here.; PARALLEL connectorThis is a 15-pin D-sub parallel control terminal.Connect an external controller here.z Heat dissipation fanThis fan is to prevent the unit from overheating. Do notallow anything to block the fan and prevent the dispersionof heat.x AC IN connector (DA-6400 only)Plug the included power cord in here.c AC IN A/B connectors (DA-6400dp only)Plug the included power cords in here.To operate the unit with power supply redundancy, connectpower supplies to both the AC IN A and AC IN B connectors.