TASCAM DA-6400/DA-6400dp 478 – Mark and Locate FunctionsLocating to a specific timeYou can locate to a specific time using a USB keyboard with anumeric keypad or a USB numeric keypad.Press the * (asterisk) key on the Home Screen to clear the takenumber and time display and enable numerical input.Use the keypad to enter numbers in the following order.• Take number: 3 digits• Time elapsed from take beginning (hours, minutes,seconds, frames): 2 digits eachFor example, enter the following numbers in order to specify thelocation 1 minute 30 seconds from the beginning of take 2.0 w 0 w 2 w 0 w 0 w 0 w 1 w 3 w 0 w 0 w 0After inputting the 11th digit, the unit will automatically locateto the specified time.The status of the unit after locating will be the same as it wasbefore (stopped, in playback standby or playing).For this reason, playback will resume at the new time only afterlocating during playback.NOTEUsing the Backspace or / key on the USB keyboard will deletethe last input number.Locating before completely specifying thetimeBefore inputting all the numbers to specify a time, you can pressthe Enter key on the USB keyboard, the MULTI JOG dial onthe unit or the 7 or 9 [CHASE] button to locate to the timespecified.For example, entering the following incomplete time.0 w 0 w 2 w 0 w 0 w 1 w 2Press the 7 button to locate to 12 minutes from the beginningof take 2.What happens after locating depends on which control waspressed.8 If the MULTI JOG dial was pressed:Playback or playback standby is resumed according to thestate before locating.8 If the 7 button was pressed:Playback starts.8 If the 9 [CHASE] button was pressed:The unit enters playback standby.