38 TASCAM DA-6400/DA-6400dp7 – Internal SettingsPARALLEL connector settingsUse the PARALLEL INPUT and PARALLEL OUTPUTpages to make parallel connector input and output settings.PARALLEL INPUT page settings8 INPUT AUX1 – INPUT AUX6This shows the current functions set for INPUT AUX1 – INPUTAUX6 of the PARALLEL connector.Select INPUT AUX1 – INPUT AUX6, and press the MULTIJOG dial to open the PARALLEL INPUT screen.When INPUT AUX1 selectedINPUT AUX1 – INPUT AUX6 itemsSet the functions for INPUT AUX1 – AUX6 of thePARALLEL connector.Options:PLAY/PAUSEPAUSE (default for INPUT AUX6)RECFADER REC (default for INPUT AUX3)FADER STARTREW (default for INPUT AUX4)F.FWD (default for INPUT AUX5)TAKE SKIP - (default for INPUT AUX2)TAKE SKIP + (default for INPUT AUX1)MARK SKIP -MARK SKIP +TAKE/MARK SKIP -TAKE/MARK SKIP +MARKNOTE• Setting multiple FADER REC and FADER START settings toINPUT AUX is not possible.• When set to FADER REC, low signal input starts recordingand high signal input stops recording.• When set to FADER START, low signal input starts playbackand high signal input pauses playback.• When set to anything other than the above, it operates withlow signal input of 50 msec or longer. (See “Note about thePARALLEL connector” on page 12.)PARALLEL OUTPUT page settings8 OUTPUT AUX1 – OUTPUT AUX5This shows the current functions set for OUTPUT AUX1 –OUTPUT AUX5 of the PARALLEL connector.Select OUTPUT AUX1 – OUTPUT AUX5, and press theMULTI JOG dial to open the PARALLEL OUTPUT screen.When OUTPUT AUX1 selectedOUTPUT AUX1 – OUTPUT AUX5 itemsSet the functions for OUTPUT AUX1 – AUX5 of thePARALLEL connector.Options:STOP TALLY (default for OUTPUT AUX1)PLAY TALLY (default for OUTPUT AUX4)PAUSE TALLY (default for OUTPUT AUX5)REC TALLY (default for OUTPUT AUX2)EOM TALLYERROR TALLY (default for OUTPUT AUX3)EOM/ERROR TLLYNOTEWhen the INFO indicator is lit red, an ERROR TALLY signal isbeing output.8 EOMThis shows the setting status of the EOM (End Of Message)function.If the available recording time (when recording or in recordingstandby) or the total remaining playback time (when playingback or in playback standby) becomes less than the set time,an EOM tally signal will be output from the pin number of thePARALLEL connector that corresponds to any OUTPUT AUX1– OUTPUT AUX5 item set to EOM TALLY or EOM/ERRORTLLY.Select the EOM item, and press the MULTI JOG dial to open theEOM screen.TIME itemSet the amount of time that will cause an EOM tallysignal to be output.Options: OFF (default), 1sec – 99sec (1sec incre-ments)