Tascam TM-D4000 Operation Manual

Also see for TM-D4000: Owner's manual Technical documentation

Settings for the TM-D4000's six Aux. Sends may be viewed andadjusted from this screen. These on-screen controls are availablein two different views: Aux View (Ch01-16) and Aux View (Ch17-32). The Aux settings for the two ST IN inputs are shown in bothviews.Use the View menu to select either of these two views. Note thatboth views may be on the screen at the same time.Click any of the PRE/POST or ON/OFF buttons to change thesesettings.The automation mode indicators show the current automationmode of the channels.The Aux. Send levels may be adjusted using the on-screen controls.Channel labels entered in the Mixer View are shown but may notbe edited here.Software Overview3.7 EQ ViewThis is a view which allows you to view and adjust the EQ parameters for a channel.Right-click in the faderarea of a channel.The word "Equalizer" willappear in a pop-up menu.Click on this pop-up to bring thewindow shown above to the front.The EQ button at the upper rightof the response curve can be usedto turn the EQ on or off for theselected channel.Alternatively, use the pull-downlist at the top of the window tochange between channels.The on-screen rotary controls or the small up/down arrows to the right of the text boxes may be used to makethe gain, frequency and Q settings for the four EQ bands. The graphic EQ response curve will change as thevalues are changed. The desired values could also be typed in directly. The software will round the valuesto the nearest valid value used by the TM-D4000. Changing the EQ settings on the mixer itself will also changethe on-screen settings and the response curve.NOTE: Some of the controls may be disabled under certain conditions. The Q setting hasno meaning when an HPF or LPF setting is selected in the Gain section of bands 1 and 4.3.8 Aux Views11