Building An Automated Mix1. Make the adjustments to the desired channels with those channels setto manual mode. When you like the new settings, stop the recording, setthe desired channels to write mode and select Capture Initial Status fromthe automation software Edit Menu. (NOTE: Only parameters that havebeen write-enabled in the Automation Items window will be saved.)2. The channels with new static settings can now be returned to manualmode for the possibility of further adjustments, or they can be placed intoread mode to ensure that the new settings won’t get accidentallychanged. (NOTE: You will always be able to make adjustments to achannel that is in manual mode, but those adjustments will not be saveduntil the above step is carried out.)1. Put desired channels into write mode, make the dynamic mix moves,then put the newly automated channels into read mode to play back thedynamic mix automation.2. If you wish to perform the moves again, the previous pass can beundone by selecting Undo from the Edit Menu in the automation softwarebefore attempting another pass. Any time old mix moves are replaced bynew ones, those channels should be in read mode before making thenew moves to ensure starting from the same settings as before the old mixmoves were made. Please refer to the following section on Real Time MixEditing.4.2 Adjusting Static Settings4.3 Creating Dynamic Mix Moves15