Setup2.4 Computer Hardware InstallationBefore installation of the Moxa CI-132 card into a PC, set switches and jumpers asshown in the diagram below.JP1ON1 2ON1 2MOXASW1: ON (default)SW2: OFFJP1: OPEN (default)JP3: OPEN (default)JP4: OPEN (default)1. Install the Moxa CI-132 card that was supplied with the TM-D4000 into an open ISAslot in your computer. Be sure the computer’s power is turned off when you install thecard!2. Turn on the computer’s power. Insert the Device Driver diskette that was includedwith the Moxa card. Make a folder labeled “MOXA” in the Program Files folder ofyour computer and copy the contents of the diskette into the MOXA folder you justcreated.3. Remove the diskette from the computer and store it in a safe place.4. Inside the MOXA folder on your computer double click the file “IO-IRQ.exe”. The IO-IRQ screen will be displayed. Select “Smartio/Industio ISA Family” (it should alreadybe selected with the other option being grayed out) and press Enter on thecomputer keyboard.5. At the bottom of the screen you will be prompted to {Enter the “ConfigurationAccess Port” in HEX:}. Type in 180 and press Enter.6. The “CI-132 series” box should be displayed. Use the cursor keys on your computer tonavigate through the parameters and set them as shown below. It is possible thatnothing will need to be changed.Port index 1 2I/O address (HEX) 180 188IRQ 10 10Speed High HighINT vector (HEX) 1c0 1c07. Press the F10 key to save the settings and finish the hardware installation.3