Tascam X-9 Owner's Manual
                                    | |
Contents
|
TASCAM X-9 Owner’s Manual 216 – FadersThe X-9 faders are not all that they appear at firstsight! Their behavior can be changed so that their“curve” can fit your way of working, so that they canbe pulled or pushed to increase the level, and theycan also start and stop other devices connected to theX-9. See below for details.Program fader “curve”The fader “curve” decides how much the signal is cutthen the fader is moved to the center position awayfrom the “full on” position.The program faders can be set individually (they donot all have to share the same setting).The titles in this illustration refer to the explanationregarding setting as given in “Program fader curve”on page 19 (15Fc).Program fader directionAs shipped, the faders on the X-9 work so that whenyou push them away from you, the level of the signalincreases. When the faders are pulled towards you,the level decreases.Some people prefer to work the other way round, sothat pulling the faders towards you increases the vol-ume. Each program fader can be set individually towork the way you prefer. See “Program faderreverse” on page 19 (16Fr) for details.Alternatively, you can set fader reverse in the fol-lowing way:1 Press and hold down a FUNCTION key andthe matching ENTER key together.2 Press the CUE key of the program to togglethe fader direction, while holding down thetwo keys above. The CUE key lights when thefader is reversed.NOTEWhen the fader direction is reversed in this way, thefader start operation (see “Program fader direction” onpage 21) is also reversed.Fader startThe program faders can be used for automated startor stop of remote devices, using the fader start/stopjacks (see “Program faders” on page 8 for details ofconnections, etc.).Whether the faders control the start/stop of theremote device is a menu setting, and you can enableor disable the fader start for each fader individually.Alternatively, you can use the following methodfor setting fader start:1 Press and hold down a FUNCTION key andthe matching ENTER key together.2 Press the program selection key (PHONO/LINE /DIGITAL or INPUT/INPUT) while hold-ing down the two keys above to toggle faderstart on or off. The selection key lights whenfader start is enabled for the program.A1nOrA2VolumeFader at full-6 dB-24 dB-12 dB |
Related manuals for Tascam X-9
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine