Task Force Tips MONSOON MONITOR Instructions For Installation, Safe Operation And Maintenance
Also see for MONSOON MONITOR: INSTRUCTIONS FOR SAFE OPERATION AND MAINTENANCEInstructions for installation, safe operation and maintenanceInstructions for installation, safe operation and maintenance
                                            | |
Contents
| 
195.3 WIRELESS MONITOR OPERATOR STATION (YE-RF-##)The storage bracket is supplied with (3) 1/4-20 stainless steel self-tapping screws. Make sure the material beneath the bracket issubstantial and thick enough to hold self-tapping screws. Make sure the area on the backside of the mounting surface is clear ofobstructions. We recommend a minimum thickness of 3/32" (.093" - 2.4 mm) in aluminum and 5/64 (.078"-2mm) in steel. See the chartin Figure 5.3.1 to determine the correct pilot hole size.Select proper location for mounting storage bracket. Panel spare required will be 6.0“ x 11.2“ (152 x 285mm). Refer to Figure 2.0 forhole dimensions. Bracket can be used as a template. Be sure spring is in position.5.3.1 MOUNTING STORAGE BRACKETFig 5.3.1 Wireless Operator StationStorage Bracket Hole DimensionsMaterial Hole Size Use Material Hole Size UseThickness Inches mm Drill Thickness Inches mm Drill5/64-3/32 .206 5.2 #5 3/32 .213 5.4 #31/8 .213 5.4 #3 1/8 .221 5.6 #23/16 .221 5.6 #2 3/16 .228 5.8 #1ALUMINUM STEELHole Size Chart For Self Tapping Screws5"[127mm]6"[152mm]Drill (3) Pilot Holes(refer to hole size chart)Mount Bracket with (3)1/4-20 Self-Tapping Screws.Tighten Securely.Spring5.3.2 INSTALLING RADIO1) Turn off power and remove lid from monitor control box. Be carefulto open lid slowly as lid will be connected to communication boardby a flat cable.2) Unplug connector with blue & white wires and removecommunication board.3) Attach antenna connector to radio board with the cable in theorientation. (figure 5.3.2a) Note, in some RC monitors, cable tiemay need to be cut to attach antenna.4) Plug radio board into communication board. (figure 5.3.2b) Becareful to line up pins.5) Plug communication board/radio board into main board. Pressdown to seat securely.6) Insert connector with blue & white wires into communication board.7) Replace lid onto box. Be sure to guide flat cable down onto motorboards and to not pinch any wires between lid and box.8) Tighten lid screws equally in a criss-cross pattern.The YE-RF-## Wireless Operator Station is supplied with a radio board that needs to be installed in the monitor control box and astorage bracket.Fig 5.3.2aFig 5.3.2b |
Related manuals for Task Force Tips MONSOON MONITOR
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine