Task Force Tips MONSOON MONITOR Instructions For Installation, Safe Operation And Maintenance
Also see for MONSOON MONITOR: INSTRUCTIONS FOR SAFE OPERATION AND MAINTENANCEInstructions for installation, safe operation and maintenanceInstructions for installation, safe operation and maintenance
                                            | |
Contents
| 
205.3.3 TEACHING ID CODE:Every monitor has a unique ID code that must be “taught or transferred” to the handheld unit. This unique ID code allows multiplemonitors to be used in one location without interference. Perform the following procedure to teach the handheld unit.-Press POWER button to turn on electronics.-Press and hold both LEFT & RIGHT buttons for 5 seconds.-Continue to press LEFT & RIGHT buttons and then press UP button for 2 seconds.-Release buttons. OSC & STOW leds will flash rapidly to indicate that the unit is in teach mode.On Handheld Unit:On Monitor Control Box:-Apply power to monitor.-Press and hold both LEFT & RIGHT buttons for 5 seconds.-Continue to press LEFT & RIGHT buttons and then press UP button for 2 seconds.-Release buttons. OSC & STOW leds will flash rapidly to indicate that the unit is in teach mode.-OSC & STOW leds on handheld unit will stop flashing after ID code is transferred.-Press DOWN button on monitor control box to exit teach mode.-Cycle power off and back on to monitor.NOTE: When the operator station is purchased at the same time as RC monitor,handheld unit will be pre-taught at factory.5.3.4 CHANGING BATTERIES:-Remove two (2) screws on backside of handheld unit and slide bottom half of rubber bumper off enclosure.-Replace batteries verifying that polarity is correct.-Replace rubber bumper and retaining screws.CAUTION Properly dispose of old batteries. Do not puncture, incinerate, or disassemble batteries.Do not mix battery types.5.4 JOYSTICK MONITOR OPERATOR STATION (Y4E-JS)5.4.1 MOUNTINGThis operator station allows the monitor to be controlled by a joystick. The installer will need to mount the joystick and connect thecables to the communication interface box or to a panel mount operator station. The joystick needs to be mounted in aweatherproof location. Example: Inside the cab of the truck.Select proper weatherproof operating location. Joystick will require 4 ½” x 4 ½” (114 x 114mm) of panel space. A depth of 4”(100mm) will be required behind the panel. Refer to Figure 5.4.1.1 for hole dimensions.After mounting, the installer may rotate the joystick up to 22 degrees in either direction. To rotate joystick, lift the rubber boot toexpose adjustable clamp. Loosen the clamping screws, rotate the joystick to desired position, and tighten clamping screws.Fig 5.4.1.1Joystick Operator Station Hole Dimensions Fig 5.4.1.2Joystick Instruction Label2-27/32(72 mm)2-27/32(72 mm)1/4 (6 mm)3 (76 mm)2(51 mm)HOLE MOUNTING DETAIL®TASK FORCE TIPSFIRE FIGHTING EQUIPMENTwww.tft.comFOG STRAIGHTSMART SHAPER1)2)NOZZLE STOPS AT FULL FOGPRESS AGAIN FOR FLUSH®TASK FORCE TIPSFIRE FIGHTING EQUIPMENTSTRAIGHTSTREAMAUXFUNCTIONTRIGGERFOG THEN FLUSH800-348-2686 • www.tft.com Y5336Install joystick instruction label nearby for quick operation reference. |
Related manuals for Task Force Tips MONSOON MONITOR
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine