Service and Repair Manual October 2019Specifications2 S® -80 XC ™ • S® -85 XC ™ • S®-80 HF • S®-85 HF Part No. 1280490GTPerformanc e Specific ati onsPerformance SpecificationsDrive speed, maximumStowed position,RT tires40 ft / 9 - 11 sec12.2 m / 9 - 11 secRaised or Extended 40 ft / 55 - 65 sec12.2 m / 55 - 65 secBraking distance, maximumHigh range on paved surface 3 - 6 ft / 0.91 - 1.8 mGradeability Refer to Operator's ManualBoom function speeds, maximum from platformcontrolsJib Boom up (S-85 XC) 25 - 35 secJib Boom down (S-85 XC) 15 - 25 secBoom up 75 - 83 secBoom down 110 - 115 secBoom extend 59 - 67 secBoom retract 57 - 65 secTurntable rotate, (360°) fully stowed 95 - 103 secTurntable rotate, (360°) boom raisedor extended210 - 250 secPlatform rotate, 160° 40 - 50 secPlatform level (10° range of motion) 20 - 22 secFor operational specifications, refer to theOperator's Manual.Hydraulic Oil SpecificationsHydraulic Oil SpecificationsHydraulic Fluid SpecificationsGenie specifications require hydraulic oils which aredesigned to give maximum protection to hydraulicsystems, have the ability to perform over a widetemperature range, and the viscosity index shouldexceed 140. They should provide excellent antiwear,oxidation prevention, corrosion inhibition, sealconditioning, and foam and aeration suppressionproperties.Cleanliness level,minimumISO 15/13Water content,maximum250 ppmRecommended Hydraulic FluidHydraulic oil type Chevron Rando HD PremiumViscosity grade 32Viscosity index 200Optional Hydraulic FluidsMineral based Shell Tellus S2 V 32Shell Tellus S2 V 46Shell Tellus S4 VX 32 ShellShell Donax TG (Dexron III)Chevron 5606ABiodegradable Petro Canada Environ MV 46Fire resistant UCON Hydrolube HP-5046Note: Genie specifications require additionalequipment and special installation instructions forthe approved optional fluids. Consult GenieProduct Support before use.Optional fluids may not havethe same hydraulic lifespan andmay result in componentdamage.Note: Extended machine operation can cause thehydraulic fluid temperature to increase beyond it'smaximum allowable range. If the hydraulic fluidtemperature consistently exceeds 200°F / 90°C anoptional oil cooler may be required.
