Rubber Track Loader5. Operator Enclosure Disassembly and Assembly5-5Figure 5-183. Reconnect the gauge connector.4. Install the light bar. Refer to Chapter 5. Light BarInstallation procedure.Lap Bar Gas Assist SpringRemoval and InstallationThe tools required for gas assist spring removal andinstallation are listed in Table 5-4. Use manufactur-er-recommended tools whenever possible.Table 5-4Required ToolsScrewdriverLap Bar Gas Assist Spring RemovalRaise Lap Bar(Shown in DownPosition)Gas AssistSpringFigure 5-191. Put the lap bar in the UP position to relieve ten-sion on the lap bar gas assist spring.RemoveRetaining ClipFigure 5-202. Using a small screwdriver, remove the retainingclip from each end of the gas assist spring.Figure 5-213. Remove the gas assist spring by pulling bothends out from the ball joints.Lap Bar Gas Assist Spring InstallationGas AssistSpring LocationRaise Lap Bar(Shown in DownPosition)Figure 5-221. Put the lap bar in the UP position to minimizetension on the lap bar gas assist spring duringinstallation.
