Outboard Bearing Removal andInstallationThe tools required to remove and install the outboardbearing assembly are listed in table 11-5. Use manu-facturer recommended tools whenever possible.Table 11-5RemovalFigure 11-151. Remove the four bolts securing the bearing to themounting plate.Figure 11-162. Remove the 3 bolts securing the mounting plate tothe drive table, then use a chisel to gently sepa-rate the two components. Remove the mountingplate from the machine.Figure 11-173. Use a hammer to drive a screwdriver in along theedge of the rubber cap. the pry the cap out asshown. (the cap must be replaced after service)Figure 11-184. Use a snap ring pliers to remove the snap ringretainer from the shaft as shown.Figure 11-195. Use a puller to remove the bearing assembly fromthe machine as shown.Installation1. To install the outboard bearing, reverse theremoval procedure.11-5Rubber Track Loader11. Undercarriage Disassembly and AssemblyRequired ToolsCombination/socket wrenchSnap ring pliersPullerHammer/chisel
