Terex PT-50 Service Manual
Also see for PT-50: Operation and maintenance manual
                                                                                     | |
Contents
| 
Drive Sprocket Removal andInstallationThe tools required to remove and install the drivesprocket assembly are listed in table 11-6. Use manu-facturer recommended tools whenever possible.Table 11-6Removal1. Perform the outboard bearing removal procedureas described on page 11-5 of this chapter.Figure 11-202. Remove the nuts securing the sprocket to the drivemotor, then carefully remove the drive sprocket.Installation1. To install the drive sprocket, reverse the removalprocedure.Drive Motor Removal andInstallationThe tools required to remove and install the drivemotor are listed in table 11-7. Use manufacturer rec-ommended tools whenever possible.Table 11-7Removal1. Perform the drive sprocket removal procedure asdescribed on page 11-6 of this chapter.Figure 11-212. Remove the bolts securing the drive motor to thedrive table as shown.Figure 11-223. Disconnect the various hoses from the drive motor(noting their positions and orientations forreassembly), then remove the drive motor from themachine. (cap or plug all tubes/hoses/fittings)Installation1. To install the drive motor, reverse the removal pro-cedure.11-6Rubber Track Loader11. Undercarriage Disassembly and AssemblyRequired ToolsCombination/socket wrenchSnap ring pliersPullerHammer/chiselRequired ToolsCombination/socket wrenchCrow’s foot |
Related manuals for Terex PT-50
manualsdatabase
Your AI-powered manual search engine