Understanding the DDW262.G Back Panel Ubee Interactive8 Ubee DDW262.G Wireless Cable Modem and Router Subscriber User Guide • September 20111.8 Understanding the DDW262.G Back PanelAll ports to connect the device are located on the back panel. The following image andtable describe the device’s back panel connections.Back Panel Label Descriptionpower Connects to the power adapter. WARNING: Useonly the power adapter shipped with this device.Failure to do so may cause damage to the device.reset Resets the device. Insert a pointed object into the opening.Press for less than10 seconds to power cycle the device.Press for more than 10 seconds to reset the device to thefactory defaults.ethernet 1 - 4 Connects an Ethernet device such as a computer, gamingconsole, or a router/hub to the Internet using a standard RJ45Ethernet cable. See the Understanding the CustomerPremises Network on page 3 for more information.cable Connects to the coaxial cable (not included) that comes fromthe cable wall outlet or cable splitter (not included).WPS Connects a PIN-protected Wi-Fi device to the cable modemwhen the Wi-Fi Protected Setup method is used. When theWPS button is pushed or triggered through the device’s WebGUI, an LED on the top-front of the device flashes for fourminutes until a PIN is entered from the wireless client, suchas a laptop computer, that wants to connect. After a Wi-Ficlient attaches successfully, the LED remains on for fiveminutes, and then turns off. Refer to Understanding theWireless Menu on page 47 for more information.
