Connecting Devices to Your Network Ubee Interactive12 Ubee DDW262.G Wireless Cable Modem and Router Subscriber User Guide • September 2011Caution – Use only the power adaptor shipped with this device. Failure to do so maycause damage the device.5. Using the Ethernet cable included in the product package, connect one end of theEthernet cable to your computer’s Ethernet port, and connect other end to theETHERNET port on the cable modem.6. Connect the coaxial cable from the cable wall outlet or a cable splitter connected tothe cable wall outlet to the CABLE port on the device.2.2 Connecting Devices to Your NetworkUse one or more of the following sections to connect network devices and validate devicefunctionality. Connecting Ethernet Devices on page 12 Connecting Wireless Devices on page 12 Troubleshooting the Installation on page 142.2.1 Connecting Ethernet DevicesYou can connect an Ethernet device to your network, such as a computer, using anEthernet cable.StepsTo connect an Ethernet device to the network:1. Verify an Ethernet device (for example, a PC) is connected to the device. SeeInstalling and Connecting the DDW262.G on page 11.2. Use the device LEDs to confirm operations. The PWR, SYNC, and READY LEDs aresolidly lit in normal operations. One of the four ETHERNET LEDs is lit when a deviceis connected to the Ethernet port. Refer to Understanding the DDW262.G Front Paneland LED Behavior on page 9 for more information.3. Open a Web browser and go to any Web site to validate network connectivity(for example, http://www.wikipedia.org).4. If the connected device is a gaming console, perform an Internet connection testprovided by your console. For more information please contact your consolemanufacturer.5. Refer to Troubleshooting the Installation on page 14 for troubleshooting information, ifneeded.2.2.2 Connecting Wireless DevicesUse these steps to connect a wireless device to the network (for example, a laptopcomputer). Use the device LEDs to confirm operations: