- 130 - © 2018 unitech Electronics Co., Ltd. All rights reserved.unitech is a registered trademark of unitech Electronics Co., Ltd.MS652 User’s Manual4.14 Decode Session TimeoutThis parameter sets the maximum time decode processing continuesduring a scan attempt. It is programmable in 0.1 second increments from0.5 to 9.9 seconds. The default timeout is 9.9 seconds. To set a DecodeSession Timeout, scan the following bar code, and then scan two barcodes from Appendix B, Numeric Bar Codes that correspond to thedesired on time. Enter a leading zero for single digit numbers. Forexample, to set a Decode Session Timeout of 0.5 seconds, scan this barcode, and then scan the 0 and 5 bar codes. To correct an error or changethe selection, scan Cancel.Decode Session Timeout