- 132 - © 2018 unitech Electronics Co., Ltd. All rights reserved.unitech is a registered trademark of unitech Electronics Co., Ltd.MS652 User’s Manual4.16 Timeout Between Decodes,Different SymbolsUse this option in presentation mode or Continuous Bar Code Read tocontrol the time the engine waits before decoding a different symbol. It isprogrammable in 0.1 second increments from 0.1 to 9.9 seconds. Thedefault is 0.1 seconds.To select the timeout between decodes for differentsymbols, scan the following bar code, and then scan two bar codes fromAppendix B, Numeric Bar Codes that correspond to the desired interval,in 0.1 second increments.Timeout Between Decodes, Different Symbols