- 67 - © 2018 unitech Electronics Co., Ltd. All rights reserved.unitech is a registered trademark of unitech Electronics Co., Ltd.MS652 User’s Manual3.8 Codabar (NW - 7)Scan one of the following bar codes to enable or disable Codabar.3.8.1 Set Lengths for CodabarThe length of a code refers to the number of characters (i.e., humanreadable characters), including check digit(s) the code contains. Setlengths for Codabar to any length, one or two discrete lengths, or lengthswithin a specific range. The default is Length Within Range: 5 to 55.Note: When setting lengths, enter a leading zero for single digit numbers.Scan one of the following bar codes to select a length option:• One Discrete Length - Decode only Codabar symbols containing aselected length. Select the length using the barcodes in Appendix B, Numeric Bar Codes. Forexample, to decode only Codabar symbols with14 characters, scan Codabar - One DiscreteLength, and then scan 1, 4. To correct an error orchange the selection, scan Cancel.• Two Discrete Lengths - Decode only Codabar symbols containing eitherof two lengths. Select lengths using the barcodes in Appendix B, Numeric Bar Codes. Forexample, to decode only Codabar symbolscontaining either 2 or 14 characters, scanCodabar - Two Discrete Lengths, and then scan0, 2, 1, 4. To correct an error or change theEnable Codabar*Disable Codabar