- 131 - © 2018 unitech Electronics Co., Ltd. All rights reserved.unitech is a registered trademark of unitech Electronics Co., Ltd.MS652 User’s Manual4.15 Timeout Between Decodes,Same SymbolUse this option in presentation mode or Continuous Bar Code Read modeto prevent the engine from continuously decoding the same bar codewhen it is left in the engine’s field of view. The bar code must be out of thefield of view for the timeout period before the engine reads the sameconsecutive symbol. It is programmable in 0.1 second increments from0.0 to 9.9 seconds. The default interval is 0.6 seconds. To select thetimeout between decodes for the same symbol, scan the following barcode, and then scan two bar codes from Appendix B, Numeric Bar Codesthat correspond to the desired interval, in 0.1 second increments.Timeout Between Decodes, Same Symbol