VDO CONTISYS OBD Instruction Manual

Also see for CONTISYS OBD -: Brochure Manual Quick reference guide Quick reference guide Instruction manual

FastCheck33It should be used if it is suspected that there is a fault with the Control Module, wiring,or the actuators (if the parking brake will not engage/disengage when manuallyoperated).Note: This function can not be performed while the parking brake system is inmaintenance mode. It should only be performed when the system is in normaloperating mode.Ensure the on screen instructions on the service tool are followed precisely and in thecorrect order.Notes on Use of functionsThe four functions are designed to be used in several different situations. Here are fewsituations which may occur and the correct use of the functions to rectify the situation:Rear Brake Pad, Brake Disc or Calliper Replacement:1. If the vehicle requires any of the above components to be replaced the 'EnterMaintenance Mode' function should be performed.2. The system will be disabled to allow maintenance work to be carried out easilyand safely.3. After the work has been carried out the 'Exit Maintenance Mode' function shouldbe performed.Any other EPB system component has been replaced:1. DTCs should be read and cleared.2. The 'Assembly Check' function should be performed to check the operation ofthe parking brake system.3. If the 'Assembly Check' function fails, DTCs should be read again and theproblem investigated.The Parking Brake will not engage when manually operated via the button:1. Ensure that the system is NOT in 'Maintenance Mode'. If it is then perform the'Exit Maintenance Mode' function.2. Read DTCs, there may be a DTC stored which will indicate the area of the fault.3. Clear DTCs, there may be an intermittent fault on the system which needs to becleared.4. Perform the 'Static Apply' function. This will send a command directly to theControl Module which will then close the actuators to the nominal 'engaged'position.5. Check the switch/button.6. Check the actuators themselves or the wiring from the Control Module to theactuators.