VDO CONTISYS OBD Instruction Manual

Also see for CONTISYS OBD -: Brochure Manual Quick reference guide Quick reference guide Instruction manual

FastCheck46Applicable vehicles:• BMW 1 series (E81/E87)• BMW 3 series (E90/E91/E92/E93)• BMW 5 series (E60/E61)• BMW 6 series (E63/E64)• BMW 7 series (E65)Note: The CAN converter (A2C59512664) harness must be used.Battery change:After fitting a new battery, the battery change function should be run. The batterychange function registers the replacement of a battery with the power managementsystem. Failure to do so may cause the power management system to operateincorrectly.The battery change application determines the required battery capacity and typefrom the Car Access System (CAS) module. The replacement battery must be samecapacity and type as displayed.Note: Certain vehicles require the use of an Absorbent Glass Mat (AGM) battery.Applicable vehicles:• BMW 1 series (E81/E87)• BMW 3 series (E90/E91/E92/E93)• BMW 5 series (E60/E61)• BMW 6 series (E63/E64)• BMW 7 series (E65)Note: The CAN converter (A2C59512664) harness must be used.GM vehiclesService interval resetCAN vehicles - (Astra-H, Corsa-D, Signum, Vectra-C and Zafira-B)For these vehicles the CAN converter cable (A2C59512664) must be used for Serviceinterval reset.This function should be used after a vehicle has been serviced.The vehicle is programmed with the number of miles and days until the next serviceand the Service indicator light is turned off.The Service indicator will come on again when either the number of programmedmiles is reached or the number of programmed days is reached, whichever occursfirst.The reset is started by selecting the 'Service' option.To return to a previous menu, press the key.The operator must then select the 'CAN Converter cable'.