Vacon NX User Manual
Also see for NX: Installation manualUser manualQuick helpUser manualUser manual
                                                                                                                                                                                                             | |
Contents
| 
7vacon • 112 CONTROL KEYPAD7.3.2 Parameter menu (M2)Parameters are the way of conveying the commands of the user to the frequency converter. Theparameter values can be edited by entering theParameter Menu from theMain Menu when thelocation indication M2 is visible on the first line of the display. The value editing procedure ispresented in Figure 64.Push theMenu button right once to move into theParameter Group Menu (G#). Locate theparameter group desired by using theBrowser buttons and push theMenu button right again toenter the group and its parameters. Use again theBrowser buttons to find the parameter(P#) youwant to edit. From here you can proceed in two different ways: Pushing theMenu button right takesyou to the edit mode. As a sign of this, the parameter value starts to blink. You can now change thevalue in two different manners:1. Just set the new desired value with theBrowser buttons and confirm the change with theEnter button. Consequently, the blinking stops and the new value is visible in the valuefield.2. Push theMenu button right once again. Now you will be able to edit the value digit bydigit. This editing manner may come in handy, when a relatively greater or smaller valuethan that on the display is desired. Confirm the change with theEnter button.The value will not change unless the Enter button is pushed. Pressing theMenu button left takesyou back to the previous menu.Several parameters are locked, i.e. uneditable, when the drive is in RUN status. If you try to changethe value of such a parameter the text*Locked* will appear on the display. The frequency convertermust be stopped in order to edit these parameters.The parameters values can also be locked using the function in menu M6 (see Chapter Parameterlock (P6.5.2)).You can return to theMain menu anytime by pressing theMenu button left for 3 seconds.The basic application package "All in One+" includes seven applications with different sets ofparameters.Once in the last parameter of a parameter group, you can move directly to the first parameter ofthat group by pushing theBrowser button up.See the diagram for parameter value change procedure on page 113.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com |
Related manuals for Vacon NX
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine