Vacon nxs/p User Manual

Also see for nxsp: User manual Installation manual

Contents

Vacon nxs/p User Manual Manual pdf 15 page image

commissioning vacon • 1524-hour service: +358-40-8371 150 • Email: vacon@vacon.com55. COMMISSIONINGREAD FIRST CHAPTER 8 'COMMISSIONING' IN VACON NX USER'S MANUAL (Document nr. ud00701,please visit http://www.vacon.com/support/documents.html).5.1 Fieldbus board parametersThe Vacon LonWorks board is commissioned with the control keypad by giving values to appropriateparameters in menu M7 (for locating the expander board menu, see Vacon NX User's Manual,Chapter 7).Expander board menu (M7)TheExpander board menu makes it possible for the user 1) to see what expander boards areconnected to the control board and 2) to reach and edit the parameters associated with the expanderboard.Enter the following menu level (G#) with theMenu button right. At this level, you can browse throughslots A to E with theBrowser buttons to see what expander boards are connected. On the lowermostline of the display you also see the number of parameter groups associated with the board.If you still press theMenu button right once you will reach the parameter group level including oneparameter(Service pin).LonWorks parametersTo commission the LonWorks board, enter the parameter G7.5.1.1 from theParameters group(G7.5.1). Give the desired value to the LonWorks parameter.# Name Default Range Description1 Service Pin 0 0..1 Broadcasts a service pin message to thenetwork.Table 5-1. LonWorks parametersArchived Document