15. OUTLET BAFFLE AND FASCIA FITTINGHomeflame Dream model.15.1 Fitting the outlet baffle.Locate the outlet baffle and secure in placeusing two tapping screws supplied (See figure29).15.2 Fitting the fascia.1. Supplied with the fire is a self adhesivecontrol position label. Peel the backing fromthe label and place as in figure 30.2. Place the fascia against the fireplace frontsurface so that the two retaining plates at theback of the fascia are above the two upperretaining brackets at the top of the convectionbox. Lower the fascia making sure that therear retaining plates locate fully into theretaining brackets on the convection box (Seefigure 30). If the inlet pipe runs along the frontof the fireplace, the bottom ofthe fascia will have to beswung forwards to clear thepipe while lowering the casting.3. Secure the bottom of thefascia using the two machinescrews and washers supplied(See figure 31).15.3 Fitting the firefrontcasting.1. The firefront casting issupplied with a black bafflefitted to its rear. This has to beremoved and replaced with thefirefront casting baffle suppliedwith the fire. To do this removethe two screws on the rear ofthe casting (See figure 32) andremove the existing baffle.Secure the new baffle in placeusing the two screws.2. Place the firefront casting© Baxi Heating U.K. Limited 2008. Page 32Figure 30. Fascia location (Fascia may differ fromthat shown).Figure 29. Outlet baffle.INSTALLER GUIDE