16. FINAL REVIEW1. COMPLETE THE INFORMATION IN THE WARRANTY AND SERVICE SECTIONOF THE OWNER GUIDE (See last pages of the OWNER guide).2. Visually inspect the appliance. Clean off any marks incurred during installation.3. Advise the customer how to operate the appliance. Point out that lighting instructiondetails are on the metal plate attached at the bottom of the appliance. Explain to thecustomer that the appliance has a flame failure & spillage monitoring system. Pointout the explanation of this system shown in the owner guide under “Operating thefire”. Advise that if the fire goes out for any reason, wait at least three minutes beforerelighting. Stress that if the monitoring system repeatedly shuts off the fire, theappliance should be switched off and a specialist should be consulted.4. Advise the customer that they should read their owner guide before operating thefire and always follow the advice in the section headed “Cleaning your fire”.5. Stress that no extra ceramic fuel effect pieces must be added over and abovethose supplied with the appliance and that any replacements must only be theauthorised spares. Warn that ignoring this advice could cause incompleteclearance of the products of combustion with consequent health hazards. If youhave not done so already; attach or place the ceramic fuel effect guide insidethis guide.6. Advise the customer that the appliance will operate to its maximum potential if theflue is primed during the first 20 – 30 minutes of use. To do this, simply slide thecontrol to its highest setting. This will also burn off any carbon deposits that may haveformed during previous use.7. Emphasise that if the glass panel is broken or damaged, the fire should beturned off and not used until the window unit is refitted with an authorisedreplacement. The fire should not be used without the glass panel fitted.8. Advise the customer that when first turned on from cold, the flames will appearpredominantly blue and it is normal for condensation to form on the rear of the glasspanel. The condensation will disappear after a few minutes use.9. If using the appliance for long periods it is beneficial to change between settings.This will also help to remove any carbon deposits that may form during use.10. Recommend that the appliance should be serviced by a competent person at leastannually.11. If the appliance is in premises in the United Kingdom occupied by a tenant, pointout that by law a landlord must have any gas appliance, flue and pipework which issituated in a tenant’s premises checked for safety at least every 12 months.12. Advise that the fire may give off a slight odour while new. This is quite normal andit will disappear after a short period of use.13. Inform the customer that the Serial number for the appliance is located onthe information label, located behind the lower front casting and underneath theburner module.14. Hand the literature pack with this guide to the customer.© Baxi Heating U.K. Limited 2008. Page 34INSTALLER GUIDE