CONTENTSSection Heading PageINSTALLER GUIDE 4 - 42OWNER GUIDE 43 - 551. SAFETY 62. ACCESSORIES 63. APPLIANCE DATA 74. GENERAL INSTALLATION REQUIREMENTS 85. PACK CONTENTS 166. FIREPLACE CHECK 187. IGNITION CHECK 198. GAS SUPPLY CONNECTION 209. PREPARING APPLIANCE FOR INSTALLATION 2010. CONVECTION BOX INSTALLATION 2410.1 Method 1 - Front fixing to fireplace surround. 2410.2 Method 2 - Cable retention and floor fixing. 2410.3 Sealing floor front - All installations. 2611. BURNER AND SUPPLY PIPE INSTALLATION 2711.3 Inlet pressure check. 2812. FITTING THE CERAMIC FUEL EFFECT 2813. FITTING THE GLASS PANEL 2914. FULL OPERATING CHECKS 3014.1 Checking the control settings. 3014.2 Check for spillage. 3014.3 Flame supervision and spillage monitoring system. 3115. OUTLET BAFFLE AND FASCIA FITTING 3216. FINAL REVIEW 3417. SERVICING & PARTS REPLACEMENT 3517.1 Checking the aeration setting of the burner. 3517.2 To remove the ignition microswitch. 3617.3 To remove the gas shut-off microswitch. 3617.4 To remove the fascia. 3617.5 To replace the control slide unit. 3717.6 To replace the control slide button. 3717.7 To remove the glass panel. 3817.8 To remove the fuel effect. 3817.9 To remove the ceramic side walls. 3817.10 To remove the electronic ignition generator. 3917.11 To remove the complete burner unit. 3917.12 To remove the thermocouple interrupter block. 4017.13 To remove the pilot unit. 4017.14 To remove the shut-off tap. 4017.15 To remove the gas flow rate controller. 4117.16 To replace the burner. 4217.17 To remove the main burner injector. 4217.18 To remove the appliance from the fireplace. 42© Baxi Heating U.K. Limited 2008. Page 5INSTALLER GUIDE