Valor Fires 761 Installation And Owner's Manual

upper retaining brackets. See section 15 of this guide for detailed fitting instructions.Homeflame Harmony model.1. Carefully lift the fascia upward and forward.2. Place the fascia in a safe place away from the gas fire.3. To fit the fascia, place the top of the fascia against the fireplace front surface sothat the two retaining plates at the back of the fascia are directly above the tworetaining brackets on the convector box. Keeping the lower part of the fascia clear ofthe ceramic fuel effect, lower the fascia making sure that the rear retaining plateslocate fully into the retaining brackets on the convection box (See figure 33). Thefascia bottom is held in place with magnets. These should be located as in figure 33.17.5 To replace the control slide unit.1. Remove the fascia (See section 17.4).2. Remove the knurled screw securing the controllinking arm to the burner (See figure 38).3. Detach the slide unit by removing two screwssecuring it to the convection box flange (See figure39).4. Replace in the reverse order.17.6 To replace the control slide button.1. Remove the fascia (See section 17.4).2. Unscrew and remove the two screws securing theslide button to the slider mechanism.3. Remove the button, replace and fit in the reverseorder.© Baxi Heating U.K. Limited 2008. Page 37Figure 39. Slider mechanismremovalFigure 38. Control linkagedisconnectionINSTALLER GUIDE