70 Configuration and Parameterization WAGO-I/O-SYSTEM 750750-658 CAN GatewayManualVersion 1.2.0, valid from FW/HW-Version 01/01Pos : 88.1 /All e Seri en ( Allgemei ne Module)/Ü bers chriften/Ebene 2/Konfigurieren und Parametrier en mit e!COCKPIT - Übersc hrift 2 @ 29\mod_1489652592780_21.doc x @ 413728 @ 2 @ 49.2 Configuration and Parameterization withe!COCKPITPos : 88.2 /Serie 750 (WAGO-I/O-SYST EM)/In Betrieb nehmen/Parametrier en mit WAGO-I/O-CH ECK/Konfigurieren und Parametrier en mit e!COCKPIT 750- 0658 (Übersic ht) @ 29\mod_1489653978259_21.doc x @ 413735 @ @ 4Configuration and parameterization differ only slightly in in e!COCKPIT andWAGO-I/O-CHECK. For that reason, only the deviations are explained that applyto the e!COCKPIT software.Configuration and Parameterization in the e!COCKPIT Software!General information on configuration and parameterization in the e!COCKPITsoftware is available in the respective manual! This manual has item No. 2759-0101 and can be downloaded at www.wago.com!There are the following deviations:• General:The “Load” and “Save” functions are automated in the application. Somefiles cannot be manually loaded or saved. Therefore, the [Open] and [Save]buttons are not available in the application menu.• Initial start of the application:When initially starting the application from e!COCKPIT, all parameters areread from the I/O module automatically. Once you exit the application, theparameters are automatically saved as “Offline parameters”.• Starting the application:When starting the application again, the existing offline parameters and theI/O module parameters are compared. If they differ, the “ParameterComparison” dialog appears. This dialog is described below.• “Parameter Comparison” dialog:Figure 37: “Parameter Comparison” DialogPos : 89 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1