Walker MC (20 HP) Owner's Manual

Also see for MC (20 HP): Illustrated parts manual

Contents

Walker MC (20 HP) Owner's Manual Manual pdf 23 page image

Assembly Instructions19Grease FittingLocationsSpacer WasherAxle Spacer TubeDeck Caster Wheel Installation5. Grease the caster wheel bearings and casterpivot bearings - one grease fitting for eachwheel and each pivot.Deck Discharge Chute Installation(GHS Rear Discharge Models Only)Mount the discharge chute hinge on top of the deckdischarge opening using the 1/4-20 x 1/2 in. socketbutton head screw and 1/4-20 ESNA nut. Positionthe screw with the head inside of the chute and thenut on the outside. Attach spring for tilt-up actionfrom chute to bracket on deck.Carrier FrameTube Sockets AttachChuteAttach GuardNut on TopDischarge Chute and PTO Shaft GuardInstallation on Rear Discharge DeckDeck Discharge Shield Installation(Side Discharge Models Only)Attach the deck side discharge shield by positioningthe shield hinge lug in front of the deck mount andfastening with two (2) 3/8-16 x 1-1/4 in. bolts, 3/8-16ESNA nuts, and 3/8 in. wave spring washers. Thewave washers fit between the two hinging surfaces.Tighten the nuts until the shield moves freely but isnot loose.WARNINGDO NOT operate the machine without thegrass deflector shield attached and in thelowest possible position.Attach ShieldDischarge Shield Installationon Side Discharge DeckPTO Shaft Guard InstallationPosition the shaft guard as shown and mount withtwo (2) 1/4-20 x 1/2 in. bolts.Tilt-Up Roller Wheel InstallationMount the two (2) tilt-up roller wheels on the brack-ets on the rear skirt of the deck housing using theP/N 8490 axle bolt, 3/8 in. wave spring washer and3/8-16 in. Whiz locknut. Tighten the axle bolt untilthe wheel rolls freely, but is not loose.