X Craft x plus one Operation Manual
                                       | |
Contents
| 
Pg. 19 v.1.1First FlightPerform preflight inspection:1. Put X PlusOne on flat, level surface2. Power on transmitter3. Install battery and connect power4. Press and hold safety button, next to battery compartment, until it is solid red (If it does not turn solidred, please disconnect the battery and restart the process). Indicator LED in the center of the wing,should be flashing green; at connection of pylon5. Arm the craft by holding the left stick down and right for several seconds6. Once armed, the motors will begin spinningWARNING: Never approach the craft when it is armed. Rotating propellers can be dangerous. Do not start the motors when there are people nearby. Always keep your hands on the remote controller so long as the motor is still spinning. Never stop the motors mid-flight unless in emergency situations when doing so can reducethe risk of damage or injury. Always stay at least 15 feet away from the rotating propellers and motors.8. Takeoff by increasing the throttle slightly above half Maintain line of sight of your aircraft at all times. DO NOT fly under the influence of alcohols or drugs. In the instance of a low battery warning, land the aircraft at a safe location.9. Familiarize yourself with how the X PlusOne responds to control inputsTIP: It is suggested that you do not attempt to transition to forward flight until you arecomfortable with hover controls.TIP: If at any time you lose orientation while in forward flight, switch to hover mode and set the throttle to full up and thecraft will right itself.10. When ready, land by performing the following:a. Return craft to takeoff pointb. Achieve stable hover at 10 ft.c. Reduce throttle to smoothly descendd. Fully reduce throttle once on the groundOptional “Return to Land” Featurea. Place Switch 1 in “Home” modeb. Fully reduce throttle once on the groundarmingcraft |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine