< cut top 2" cut 1">DIIIIIIIIHHHHHHHHIIIIIIIIIIIII4-2PrintingSELECTING FONTSFonts are selected through your applicationsoftware, through printer commands to select afont, or for PCL 5 at the control panel. Thefont you select is used unless you change it.Fonts are selected by the Xerox Configurationand Resource Utility for Twinax and Coaxprinting.Default Font for the PCL 5 ModeYou may select a default font for the PCL 5mode either through a PCL 5 command set,through your application software, or byaccessing the PCL 5 SETUP option at the PrinterSetup Menu. The default font you select at themenu is used unless you:F Change your selection at the menu.F Select a different font through yourapplication software.F Send a printer command to select a font withyour document.A factory default font has been established forthe PCL 5 mode and is listed on the PrinterSetup Menu for the PCL 5 SETUP.SENDING A PRINT JOBBefore you begin to print, make sure that theinterface cable or cables between the hostXEROX 4219/MRP Mid Range Systems PrinterXEROX 4215/MRP Mid Range Systems Printer
