< cut top 2" cut 1">DIIIIIIIIHHHHHHHHIIIIIIIIIIIIIOperator Guide 4-3If the Xerox IPDS option is installed, thenIPDS data also is supported by the printer.NOTE: The Other I/O (twinax or coax) interfacemust always be set for “Emulation sensing” tofunction for processing IBM SCS or IPDS data.To dedicate a communications port to receive aspecific printer language, refer to Chapter 2,“Using the Control Panel.” For an example ofhow to do this, refer to “Printer ConfigurationExamples” in Chapter 2.Send a job from your host computer to beprinted. Refer to the manual provided withyour application software or host operatingsystem for specific instructions on printing.LAST PAGE IS NOT EJECTEDIf “Waiting...” still displays after theprinter activity has stopped and no more pagesare ejected, refer to the following.When Using PCL 5 Command Set or IBM SCS orIPDS emulationsYou must manually eject the remaining page ofthe document or wait until the printer timesout. When the printer times out, the remainingpage prints. To manually eject the page,follow these steps:XEROX 4219/MRP Mid Range Systems PrinterXEROX 4215/MRP Mid Range Systems Printer